Heat exchanger design project Coursework Example | Topics and Well Written Essays - 2500 words

Heat veerr design project - Coursework ExampleThe Flowrate of the system is to be knowing to be 10,560 kg/hr The design also aims at getting the heat exchanger using hot Ethylene glycol which at the entre shall be at a temperature of 350 K. At the outlet, the design is to have the hot ethylene at the temperature of 310K. At the same time, the design Pressure at the aspiration is to be 2 atm. 2 Background Shell and Tube Heat Exchangers A shell and tube Heat Exchanger works with the principle that a series of twin tubes run through a shell that is filled with a wandering that takes the heat from the series of parallel tubes. The tubes transfer heat into the fluid primarily through conduction and convection. It is a very effective heat exchange system where the heat is ejected from the pipes with a lot of ease. This mechanism of heat exchange is the most commonly used in industries as opposed to the numerous other mechanisms that are available. The walls of the tubes are key in th e transfer of the heat from the parallel tubes to the coolant running in the shell. S & T Heat Exchanger Design Standards The Shell & Tube Heat Exchanger types are typically knowing such that they are in such a wide range of shapes and sizes. The sizes usually range from 6 inch all the way to a whopping 40 inch just in their diameter. On the other mint, their usual length normally varies from just a meager 3 feet all the way to a whopping 40 feet over and above the heads of the tube. Also as per the designs of the Heat Exchangers, their usual design pressure which they can accommodate is upto a pressure of 20 Kg for every sq.cm gauge. This is on the tube side walls and shell side walls. The design of the Heat Exchangers follows the fabrication standard of ASME / TEMA unfired vessels pressure codes and ASHRAE requirements standards. The climate of the area at a lower place consideration changes seasonally and rivet holes should have a broad tolerance accordance to the four season s of the world. It has extreme end pinnacles whose temperatures go beyond the melting point of water. Under changing environmental temperature conditions, materials tend to expand and contract. In this regard, the heat exchanger system has to be designed in way that considers the expansion and abbreviation of materials. The system has to be made with more flexible tolerances and fits to allow for the expansion and contraction of the materials (I). The best method for the joining of the parts of the system should be whiz which allows for the expansion and contraction of materials. In this regard, permanent material joining methods like welding are inappropriate. The use of rivets is recommended. The rivets should be such that they allow the joined materials board to expand and contract relative to one another. To achieve this, the rivets and the rivet holes should be designed with a great tolerance fit. The system should also be designed in a way that permits regular repairs and maintenance. It should not be rigidly enclosed. More or less all systems tend to break down at some point in the course of their work time. This calls for an entry point to check up the internal portions of the system. In this regard, it is in appropriate to design a system which is permanently enclosed within a system. Entry points can be made from several wide ranges of mechanisms. The design incorporates all the conditions at hand so as to have the heat within the system are within the constraints that are bearable for